-Remove engine and prop, close stern tube.
-Construct transom beam and install outboard motor mount.
-Remove engine through hulls and restore hull openings.
-Clean and prep hull below water line, base coat with coal tar epoxy, finish coat with coal tar epoxy and copper flour.
Transom beam installed and hull cleaned and sanded. Hull above water line sanded, primed and painted.
Hull below water line painted with coal tar epoxy.
Hull below water line finish painted with coal tar epoxy and copper flour.
Outboard serviced, alternator added and hung on transom beam. Down position. Copper patina developing.
In the travel lift sling ready for splash
No comments:
Post a Comment